with the rapid development of modernization, people’s living standards are constantly improving, and people’s pursuit of life is also constantly improving. It is precisely because of this that people will think about how to make themselves the most convenient, and this kind of automatic water dispenser is one of them, This is also a good choice for you, and I hope you can make good use of it.
and for this kind of automatic water dispenser, in fact, there are a variety of varieties in the society, and people use it more frequently. Here are some information about this kind of automatic water dispenser. The working principle of
water dispenser refrigeration is
1. Press the refrigeration switch, the power is connected, the refrigeration green indicator light is on, and the compressor starts to run.
2. The compressor can suck back the refrigerant vapor which has been absorbed and vaporized in the evaporator, compress it into high temperature and high pressure gas, and send it to the condenser.
3. The refrigerant vapor is cooled to the outside through the condenser to form a high-pressure liquid. The condensed liquid then flows into the evaporator through capillary throttling and depressurization to absorb the heat of the cold bladder. The heat absorbed is the heat of water and electricity at normal temperature, so that the water temperature gradually drops. Then the refrigerant liquid is sucked back by the compressor.
4. The above is a complete refrigeration process, but generally this process is continuously circulated to achieve the purpose of cooling.
5. When the water temperature drops to the set temperature with time, the contact of the refrigeration temperature controller will be disconnected, the refrigeration green indicator will be off, the compressor will stop running and turn into the heat preservation condition.
6. After the power failure, the water temperature rises gradually. When it rises to the set temperature, the contact of the refrigeration thermostat closes, the power is connected, the green indicator light is on, and the compressor runs. In this way, the water temperature is controlled between 4 ℃ and 12 ℃.
hot working principle of drinking water machine
1. Press the heating switch, turn on the power, turn on the heating circuit, the red heating indicator light is on, and the electric heating tube is hot.
2. When the water temperature rises to the set temperature, the automatic reset thermostat will automatically cut off the power supply, the red heating indicator will go out, and turn to the heat preservation condition.
3. After the power failure, the water temperature drops gradually. When it reaches the set temperature, the contact of the temperature controller closes, the power is turned on, the red heating indicator lights up, and the electric heating tube heats up again.
4. According to the above heating mode, the water temperature is controlled between 85-95 ℃ by the drinking water machine.
drinking water machine working temperature insurance device
condensing cooling drinking water machine generally has temperature insurance control device, which can protect according to the temperature change. When the circuit is overheated, the protection device will automatically fuse or disconnect the circuit when it is overloaded, which plays a role of safety protection.
through the above understanding and introduction, I think you can have a certain understanding of this kind of automatic water dispenser. At the same time, I hope you can help from the above knowledge. At the same time, I hope you can read more relevant books to enhance your knowledge level, and usually do more practical things.