Teach you how to remove the bubbles in the mobile phone film

teach you how to remove the bubbles in the mobile phone film

in order to protect the smart phone screen, we all like to apply the film on the screen, because the film needs certain technical content, it will produce bubbles if it is not pasted well. Today Xiaobian will teach you how to remove bubbles in the film. Let’s get to know!

plastic film bubble removal method:

1, preparation tools: scissors and transparent tape, and a small piece of cloth

2, first use a small piece of cloth to push out the bubble that can be squeezed out. Fold the cloth a few times and use its edge to push bubbles.

3. There are still some bubbles that can’t be pushed out. Why can’t they be pushed off? Because there is dust, which forms bubbles in the dust. We need to take out the dust method to remove the bubbles.

4. Cut the transparent tape one to two inches long and stick it next to the dust bubbles on the film. Then cut a small piece of transparent tape with the adhesive side up.

5. At this time, use one hand to pull up the transparent tape attached to the film, and use it to pull up a seam of the film. As long as you pull a seam, you can let the tape of the other hand in. Here, in order to let you see clearly, if you pull too much, it is easy to get more dust.

6. After pulling it up, you can see whether there is dust on the film or on the mobile phone screen. Look carefully, the dust is very small, and then use the transparent tape on the other hand to stick the dust. The dust sticks out. You see, there are no bubbles. We remove the other dust in the same way.

toughened film bubble removal method:

method 1: blow with a hair dryer

method is to use the heat of the hair dryer to soften the toughened film, blow the bubble with hot air for a period of time, and then press the bubble hard for a period of time, so that the toughened film is easier to fit the mobile phone screen.

advantages: bubbles in the screen are easy to remove.

disadvantages: do not grasp the blowing time and heat, easy to damage the screen. This method is better than the other one.

method 2: use the clip clip

to find a clip with larger clamping force. Before going to bed at night, hold the bubble at the edge of the mobile phone screen for one night. After getting up the next morning, I was surprised to find that the bubble disappeared!

advantages: simple, easy to find and buy tools.

disadvantages: if the clip slips, the edge of the mobile phone will be scratched by the iron edge of the clip, so the owner accidentally damages the paint of the mobile phone.

method 3: use human body lubricant or liquid glue

. The phenomenon is that there are bubbles at the edge of the screen all the time. After pressing down, the bubbles are gone at that time, but they will appear again later. This kind of bubble is often distributed at the edge of the screen, and the air always enters through the gap between the toughened film and the screen.

the usage method is to take a small amount of liquid on toothpick and other objects, gently open the edge bubble, force the liquid to slowly flow into the bubble, so that the liquid fills the gap between the screen and the toughened film. Don’t forget to press the bubble during this period. This method is very good and doesn’t do much harm to the mobile phone. But there are some technical requirements.

Leave a comment

Your email address will not be published. Required fields are marked *